Blog

Residential Roofing: 3 Most Common Roof Leak Repairs

As a homeowner, you’d like your roof to maintain its integrity over the years but common wear and tear and following roof leaks are inevitable. Roofing repairs are simply part of roof’s life.

While there are many reasons for roof’s deterioration, some roof areas are more prone to leaking than others. Skylights, chimneys and vent pipes all provide an opportunity for moisture to get through, especially in older roofs or when they have not been installed properly.

Residential Roofing: 3 Most Common Roof Leak Repairs

1. Leaky Skylight Repairs

A leaky skylight can be a homeowner’s worst nightmare. Most often than not, an improper installation is the cause of a leak. If that’s the case, your local roofing contractor must handle the repairs to avoid further damage.

Some common situations that cause skylights to leak are: improperly installed fasteners, poor flashing seals, glass micro-fractures or fissures and sealant failure due to thermal expansion. If the skylight leak is at the roof flashing, it may be possible to make temporary repairs using roof flashing cement around the perimeter of the unit. However, proper repairs will require removing shingles near the skylight, installing appropriate flashing, and reinstalling new shingles in the area. Most skylights have integral flashing or a special flashing kit that is specifically designed for the skylight and roofing material.

A thorough roofing inspection will help your roofer uncover any problems with your skylights and suggest appropriate repairs so that should be your first step.

2. Chimney Flashing Repairs

Damage to the chimney structure is quite common as well, as chimneys can develop cracks and crevices that allow water to permeate them. Instead of keeping rain and snow out of the roof seams, sub-par flashing allows the moisture into the roof’s inner structure. Water seepage can cause mildew, mold and premature aging of the roof.

To fix this problem, start with a thorough inspection of your chimney base and walls looking for gaps, cracks and obvious wear and tear. Chimney flashing needs to be replaced when it becomes rusty, corroded, chipped, or broken. Masonry caulk can seal small gaps or holes on a short-term basis, but is not designed to take the place of the flashing. Depending on what you find, roofing cement, caulking and most often than not flashing will need to be replaced.

Since improperly installed flashing leaves your home unprotected from rain and snow it is always best to have a professional roofer address more extensive flashing problems.

3. Vent Pipe Repairs

Aside from skylights and chimneys, roof vents are one of the most common causes of roof leaks. Rusty and cracked vent pipe collars around their base allow the water to first pool around, then seep through the interior walls of your home.  Again deteriorated flashing & old roof cements & sealants might be the reason behind vent pipe leaks.

Occasionally, vent pipe leaks can also occur at the collar surrounding the base of the vent pipe where it breaks through the surface of the roofing material. When this occurs, rainwater can seep in between the rubber boot and the vent pipe and accumulate in your home, causing damage. If the rubber boot collar is cracked or damaged, it will need to be replaced.

Need a Pro to Handle Your Roofing Repairs?

If your roof is leaking contact a professional roofer for an inspection and repairs.

Contact Eagle Prime Construction, LLC, your Houston roofing repair contractor with over 13 years of experience examining and repairing all types of roof problems. We’re here to help with all your roofing needs, and are available to assist you with roof leak repairs, new installations and roofing inspections.

Share this post